Table of Contents
Advertisement
9.5.1.2
SINGLE SLAVE
Main Menü || AS-I SAFETY || TEACH CODES || SINGLE SLAVE ||
This menu point allows you to teach the code table for a safe slave. Proceed as
follows:
•
Use the arrow keys to navigate to the third line (0000) on the display
•
Enter the PIN there
•
Use the arrow keys to navigate to the fourth line (OK) on the display
•
Confirm your entries with OK
In the following menu:
•
Use the arrow keys to select the AS-i circuit (1/2)
•
Confirm with OK
After selecting the AS-i circuit the safe unit switches to configuration mode.
In the following menu:
•
Use the arrow keys to navigate to the second line (– –1) on the display
•
Confirm with OK (display flashes)
•
Use the arrow keys to enter the desired address
•
Confirm with OK (display stops flashing)
•
Use one of the two arrow keys to exit the input screen
•
Save with OK, or cancel the process by pressing ESC.
Information!
Be sure that all slave contacts on the corresponding slave are closed.
The teaching procedure was successful if an OK appears in the third line.
70
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
AS-i 3.0 EtherNet/IP Gateway with integrated Safety Monitor
TEACH CODES
ENTER PIN
0000
OK
AS-i CIRCUIT 1
AS-i CIRCUIT 2
TEACH CODES
SLAVE ADDR.
ESC
...
HELP
Operation in advanced display mode
––1
OK
⇓
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
Advertisement
Table of Contents
