Table of Contents
Advertisement
7.5
Diagnostics interface
The service and diagnostics interface (in conjunction with AS-i Control Tools or
ASIMON 3 G2 software) is used for communication between the PC and the unit.
7.5.1
Diagnostics port RS 232
The service and diagnostics interface is configured as a mini DIN-6 female and it
is placed on the front plate, on the left hand side.
7.6
Chip card
The configuration is stored in a fixed installed EEPROM and can be overwritten
by the chip card. The chip card does not have to be inserted in operation.
Warning!
Power must always be turned off when removing or inserting the chip card!
7.7
EtherNet/IP interface
A
B
The EtherNet/IP interface consists of two RJ-45 sockets. It is placed on the left
housing side (see section <Overview of terminals, indicators and operating ele-
ments>). The RJ-45 socket is based on the MDI (none auto-crossover) and sup-
ports 10 Base T or 100 Base TX networks according to the IEEE 802.3
40
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
AS-i 3.0 EtherNet/IP Gateway with integrated Safety Monitor
Electrical connection
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com
Advertisement
Table of Contents
