Test (Test Tools For Slaves); As-I Circuit (Selecting The As-I Circuit) - Pepperl+Fuchs VBG-EN-K30-DMD-S16 Manual

Information!
When working with a double master (AS-i master and two AS-i networks) the AS-i net-
work must be selected first by using the arrow and the OK buttons.
9.8

TEST (Test tools for slaves)

Main menu || TEST ||
After selecting the menu TEST a warning message is displayed, pointing out, that
it is possible during this test that outputs are set and that the host may loose con-
trol over the network.
Pressing the OK button continues with the actual test, ESC/SERVICE cancels the
process.
The menu TEST contains the following sub-menus:
SLAVE TEST TOOL: Testing the selected slave
BINARY INPUTS: State of the binary inputs
BINARY OUTPUTS: State of the binary outputs
ANALOG INPUTS State of the analog inputs
ANALOG OUTPUTS: State of the analog outputs
PARAMETERS: Value of the current AS-i parameter
9.8.1

AS-I CIRCUIT (Selecting the AS-i circuit)

Main Menu || TEST ||
100
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
AS-i 3.0 EtherNet/IP Gateway with integrated Safety Monitor
AS-i CIRCUIT 1
AS-i CIRCUIT 2
WARNING:
OUTPUTS MAY BE
SET AND HOST MAY
LOOSE CONTROL.
SLAVE TEST TOOL
BINARY INPUTS
BINARY OUTPUTS
ANALOG INPUTS
ANALOG OUTPUTS
PARAMETERS
AS-i CIRCUIT 1
AS-i CIRCUIT 2
Operation in advanced display mode
© Pepperl+Fuchs, Printed in Germany
Internet http://www.pepperl-fuchs.com