Danfoss VLT AutomationDrive FC 302 Operating Manual page 5

Operating Guide | VLT® AutomationDrive FC 302
6.5 Starting Up the Drive for the First Time
6.6 Parameter Settings
6.6.1 Parameter Setting Overview
6.6.2 Uploading and Downloading Parameter Settings
6.6.3 Restoring Factory Default Settings Using the Recommended Initialization
6.6.4 Restoring Factory Default Settings Using Manual Initialization
7 Wiring Configuration Examples
7.1 Application Examples
7.1.1 Programming a Closed-loop Drive System
7.1.2 Wiring Configuration for Automatic Motor Adaptation (AMA)
7.1.3 Wiring Configuration for Automatic Motor Adaptation without T27
7.1.4 Wiring Configuration: Speed
7.1.5 Wiring Configuration: Feedback
7.1.6 Wiring Configuration: Run/Stop
7.1.7 Wiring Configuration: Start/Stop
7.1.8 Wiring Configuration: External Alarm Reset
7.1.9 Wiring Configuration: RS485
7.1.10 Wiring Configuration: Motor Thermistor
7.1.11 Wiring for Regen
7.1.12 Wiring Configuration for a Relay Setup with Smart Logic Control
7.1.13 Wiring Configuration: Mechanical Brake Control
7.1.14 Wiring Configuration for the Encoder
7.1.15 Wiring Configuration for Torque and Stop Limit
8 Maintenance, Diagnostics, and Troubleshooting
8.1 Maintenance and Service
8.2 Heat Sink Service
8.2.1 Heat Sink Access Panel
8.2.2 Removing Dust Buildup from the Heat Sink
8.3 Status Messages
8.3.1 Status Message Overview
8.3.2 Status Messages - Operating Mode
8.3.3 Status Messages - Reference Site
8.3.4 Status Messages - Operation Status
8.4 Warnings and Alarms
8.5 Troubleshooting
9 Specifications
9.1 Electrical Data
9.1.1 Electrical Data, 380-500 V AC
9.1.2 Electrical Data, 525-690 V AC
9.2 Mains Supply
Danfoss A/S © 2019.12
Contents
71
72
72
72
73
73
74
74
74
76
76
77
79
82
85
88
89
89
91
92
93
94
95
97
97
97
97
97
98
98
99
99
100
102
127
130
130
130
132
135
AQ275652476278en-000101 / | 5