Danfoss VLT AutomationDrive FC 302 Operating Manual page 111

Operating Guide | VLT® AutomationDrive FC 302
Troubleshooting
HIGH VOLTAGE
AC drives contain high voltage when connected to AC mains input, DC supply, or load sharing. Failure to perform installation,
start-up, and maintenance by qualified personnel can result in death or serious injury.
Only qualified personnel must perform installation, start-up, and maintenance.
-
• Disconnect power before proceeding.
• Remove the power from the drive and check motor phase U.
8.4.30 ALARM 31, Motor Phase V Missing
Cause
Motor phase V between the drive and the motor is missing.
Troubleshooting
HIGH VOLTAGE
AC drives contain high voltage when connected to AC mains input, DC supply, or load sharing. Failure to perform installation,
start-up, and maintenance by qualified personnel can result in death or serious injury.
Only qualified personnel must perform installation, start-up, and maintenance.
-
• Disconnect power before proceeding.
• Remove the power from the drive and check motor phase V.
8.4.31 ALARM 32, Motor Phase W Missing
Cause
Motor phase W between the drive and the motor is missing.
Troubleshooting
HIGH VOLTAGE
AC drives contain high voltage when connected to AC mains input, DC supply, or load sharing. Failure to perform installation,
start-up, and maintenance by qualified personnel can result in death or serious injury.
Only qualified personnel must perform installation, start-up, and maintenance.
-
Danfoss A/S © 2019.12
W A R N I N G
W A R N I N G
W A R N I N G
Maintenance, Diagnostics, and
Troubleshooting
AQ275652476278en-000101 / 130R0709| 111