YASKAWA Z1000U Series Programming Manual page 70

1.6 F: Option Settings
No.
F6-01
Setting 0: Ramp to Stop (Use the Deceleration Time Set to C1-02)
Setting 1: Coast to Stop
Setting 2: Fast Stop (Use the Fast Stop Time Set to C1-09)
Setting 3: Alarm Only (Continue Operation)
Setting 4: Alarm Only (Continue Operation Using the Frequency Reference Set in d1-04)
Setting 5: Alarm Ramp to Stop
n F6-02: External Fault from Comm. Option Detection Selection
Determines the detection method of an external fault initiated by a communication option (EF0).
No.
F6-02 External Fault from Comm. Option Detection Selection
Setting 0: Always Detected
Setting 1: Detection during Run Only
n F6-03: External Fault from Comm. Option Operation Selection
Determines drive operation when an external fault is initiated by a communication option (EF0).
No.
F6-03 External Fault from Comm. Option Operation Selection
Setting 0: Ramp to Stop
Setting 1: Coast to Stop
Setting 2: Fast Stop
Setting 3: Alarm Only (Continue Operation)
n F6-06: Torque Reference/Torque Limit Selection from Comm. Option
Selects whether torque reference and torque limit values are assigned to the drive from the network.
No.
F6-06 Torque Reference/Torque Limit Selection from Comm. Option
Setting 0: Disabled
Setting 1: Enabled
n F6-07: NetRef/ComRef Function Selection
Selects the treatment of multi-step speed inputs when the NetRef command is set.
No.
F6-07
Setting 0: Multi-step Speed Operation Disabled
Multi-step speed input frequency references are disabled when the NetRef command is selected.
70
Parameter Name
Communications Error Operation Selection
Parameter Name
Parameter Name
Parameter Name
Parameter Name
NetRef/ComRef Function Selection
YASKAWA ELECTRIC SIEP C710636 10C Z1000U HVAC MATRIX Drive Programming Manual
Setting Range
0 to 5
Setting Range
0, 1
Setting Range
0 to 3
Setting Range
0, 1
Setting Range
0, 1
Default
1
Default
0
Default
1
Default
0
Default
0