Otto Bock 1C62 Triton Harmony Instructions For Use Manual page 32

When replacing the Functional Ring at the recommended service interval, wipe all old grease
from the shaft and bearings, apply new grease, and replace the two o-rings on the shaft. These
o-rings do not affect vacuum performance. They are used to cushion undesirable but necessary
movement in the bearing system.
5 Liability
The manufacturer recommends using the device only under the specified conditions and for the
intended purposes. The device must be maintained according to the Instructions for Use. The
device must only be operated with tested modular components in accordance with the Otto Bock
MOBIS® Mobility System. The manufacturer is not liable for damage caused by component com-
binations that were not authorized by the manufacturer.
6 CE Conformity
This device meets the requirements of the 93/42/EEC guidelines for medical devices. This device
has been classified as a Class I device according to the classification criteria outlined in appendix
IX of the guidelines. The declaration of conformity was therefore created by Otto Bock with sole
responsibility according to appendix VII of the guidelines.
32