Festo CMSX-C-U-F1 Series Manual page 51

Hide thumbs Also See for CMSX-C-U-F1 Series:

Table of Contents

CMSX-...-C-U-F1-...

After successful initialization has been completed, the display shows the following message:

AutoInit

With this, initialization is completed.

If an error is displayed, automatic initialization must be started again or manual initialization carried

out again. Then briefly press the Set button as often as necessary until the menu is displayed again.

Then repeat automatic initialization or carry out manual initialization (è Section 7.7.4).

7. Briefly press the Set key. Then the first command in the menu is displayed again.

*INITIA*

Autoinit

8. To switch back to the main menu, briefly press the Set key. The CMSX then displays menu 6 again.

6 INIT

9. If the initial position should be displayed again, press the Set key for approx. 3 s. Then the CMSX

displays the initial position again, e.g.:

−−− 0.0%

VP: 0.0%

Festo – CMSX-...-C-U-F1-... – 1506a English

Table of Contents

Show Quick Links

Table of Contents