Conclusion Of Commissioning; Operation; Maintenance And Care - Festo CMSX-C-U-F1 Series Manual

CMSX-...-C-U-F1-...
7.7.6

Conclusion of commissioning

To complete commissioning, proceed as follows:
1. Recommendation: Save your settings with the command Set as def (è Menu 6) as individual pre­
settings.
2. Mount the housing cover with an Allen key – width across flats (SW) 3 mm, tightening torque 1.5 Nm
± 10 %. When mounting the housing cover, make sure the seal is not twisted in the slot of the cover.
The seal must be undamaged and free of contamination.
8

Operation

Warning
Accidental movements of the drive can cause damage.
• Observe that the fast-switching valves of the CMSX take the neutral position if there
is a failure of the operating voltage supply (è Section 3.2).
• If you would like to prevent the neutral position of the fast-switching valves from
being effective when the power supplies are switched on (è Section 3.2), first
switch on the operating voltage supply and the setpoint input, and only then the
compressed air supply.
• Observe the operating conditions.
• Observe permitted limit values.
After the supply voltage is switched on, the CMSX is in the same operating status and the same operat­
ing mode that was valid before the supply voltage was switched off.
After commissioning has taken place, this is typically:
– Operating mode automatic (Auto)
– Operating status controller in operation (Running)
The CMSX shows the analogue specified setpoint position and the current valve position in percent and
adjusts the valve position correspondingly.
SP: 12.0%
VP: 12.1%
The CMSX behaves as follows:
– The controller is active and controls the semi-rotary drive to the analogue specified setpoint posi­
tion.
– If the operating voltage supply is switched off, the fast-switching valves of the CMSX take on the
neutral position (è Section 3.2).
9

Maintenance and care

The device is maintenance-free if used as intended in the operating instructions .
• Clean the outside of the product with a soft cloth. The permissible cleaning agent is soap suds.
54 Festo – CMSX-...-C-U-F1-... – 1506a English