Characteristic Curve Menu (4) - Festo CMSX-C-U-F1 Series Manual

CMSX-...-C-U-F1-...
7.6.8

Characteristic curve menu (4)

In this menu, a user-defined process valve characteristic curve can be established through 21 setpoint
value support points. The respective characteristic flow values of the process valve used are assigned
to these support points.
Note
Observe that changing support points in the Running operating status is effective imme­
diately – without pressing the Set key.
Display Description
MENU 4 CURVE
Support point for setpoint signal 0 % (presetting 0 %)
0 %
0.0 ...
Support point for setpoint signal 5 % (presetting 5 %)
5 %
...
...
Support point for setpoint signal 100 % (presetting 100 %)
100 %
Tab. 20 Characteristic curve menu (4)
MENU
4 CURVE
1
Support points for setpoint signal
2
Setpoint position SP [%] (value of the
support points)
Fig. 31 Move in the characteristic curve menu (4) - example support point 0 %
Operation
Briefly press Add
Briefly press Sub
Briefly press Set
Press Add long
Press Sub long
Press and hold Set
1) If the limit value is reached, the setpoint value immediately jumps over to the minimum or maximum setpoint value!
Tab. 21 Operation in the characteristic curve menu (4)
Festo – CMSX-...-C-U-F1-... – 1506a English
Setpoint position SP in % related to the defined work range
1 2
3
*CURDEF*
0 % 0.0
6
5 % 5.0
... ...
95 % 95.0
100 % 100
Selection in the CURDEF menu
1 Increase support point by 0.1 % – with overflow
2 Decrease support point by 0.1 % – with overflow
3 Confirm current value and continue to the next support point
4 Increase support point continuously by 1 – with overflow
5 Reduce support point continuously by 1 – with overflow
6 Back to the main menu
1: +
2: -
4: ++
5: --
3
3
Edit value (è Tab. 21)
3
1)
1)
1)
1)
43