Festo CMSX-C-U-F1 Series Manual page 31

CMSX-...-C-U-F1-...
Starting from the initial position, pressing the Set key causes continuation within the basic menu level
(è Fig. 21). After continuation occurs once, the current operating status is displayed. The following
operating statuses are possible:
Operating statuses
Display Meaning
Controller is
•ACTUAT•
in operation
Running
Controller is
•ACTUAT•
Stopped
Stopped
(Presetting)
Tab. 8 Operating statuses (Running, Stopped)
Operation
Briefly press Add
Briefly press Sub
Briefly press Set
Tab. 9 Operation with display of the operating status
After the Add or Sub button is pressed (è Fig. 21), the controller is immediately started or stopped.
After the Set button is pressed, the active operating mode is displayed.
Operating mode
Display Meaning
Automatic op­
•OPERAT•
eration
Auto
Manual over­
•OPERAT•
ride
Manual
Tab. 10 Operating modes
Operation
Briefly press Add
Briefly press Sub
Briefly press Set
Tab. 11 Operation with display of the operating mode
From the initial position, you change into the menu level through long pressing of the Set key
(approx. 3 s) (è Fig. 21).
Festo – CMSX-...-C-U-F1-... – 1506a English
Brief description
If no control signal is present at the digital control port D-IN, the
analogue setpoint position specified in automatic operation and,
in manual override, the manually set setpoint position, is
effective. Otherwise, the command configured for the control
port D-IN is executed (è Tab. 16).
The CMSX does not react to setpoint inputs but only to control
signals at the D-IN control port.
Controller is in operation
1 Stop controller immediately
2
3 Continue within the basic menu level (è Fig. 21)
Brief description
CMSX is in the automatic mode (presetting). The CMSX is normally
operated in this operating mode.
CMSX is in manual override.
Automatic operation
1 Select manual override
2
3 Confirm selection and continue within the basic menu level
Controller is stopped
Start controller immediately
Manual override
Select automatic operation
31