Festo CPX Series Brief Description
Positioning module
Hide thumbs
Also See for CPX Series:
- Manual (446 pages) ,
- Electronic manual (232 pages) ,
- Description (156 pages)
Related Manuals for Festo CPX Series
Summary of Contents for Festo CPX Series
- Page 1 CPX-Terminal Brief description Positioning module type CPX-CMAX-C1-1 – English 8107469 2019-02a [8107471]...
- Page 2 Translation of the original instructions Documentation on the product For all available product documentation è www.festo.com/pk Copyright: Festo AG & Co. Ruiter Straße 82 73734 Esslingen Germany Internet: http://www.festo.com E-Mail: service_international@festo.com Reproduction, distribution or sale of this document or communication of its contents to others without express authorization is prohibited.
- Page 3 User instructionsEnglish The axis controller of type CPX-CMAX-C1-1 is intended exclusively for use in CPX terminals from Festo in conjunc tion with suitable components. The maximum values specified in the section “Technical specifications” must be observed here. Detailed information on the pneumatic positioning system with the CMAX can be found in the System Manual for the CMAX type P.BE-CPX-CMAX-SYS-...
-
Page 4: Connection And Display Components
No display for X axis MC axis If green is lit: Positioning job completed (MC = 1) (green) Off: Positioning job active (MC = 0) or initialisation Normal operating status: PL lights up yellow, does not light up. Festo CPX-CMAX-C1-1 2019-02a English... -
Page 5: Installation Instructions
Perform commissioning again with the Festo Configuration Tool; see system manual for the CMAX. You can find the current version in the Internet under: è www.festo.com → Downloads → Download Area: Soft ware, drivers and firmware → Enter search term: CMAX 3.2 Mounting The CMAX is mounted in an interlinking block of the CPX terminal. - Page 6 Tighten the screws by hand in diagonally opposite sequence. Tightening torque 0.9 … 1.1 Nm. 3.3 Pin assignment of axis connection Assignment +24 V logic voltage +24 V load voltage CAN_H CAN_L Housing Cable shield Festo CPX-CMAX-C1-1 2019-02a English...
-
Page 7: Technical Specifications
Protection against electric shock By means of PELV power (protection against direct and indirect circuit contact as per IEC/DIN EN 60204-1) (Protected Extra Low Voltage) Module code (CPX-specific) Module identifier (in the Handheld) CPX-CMAX-C1-1 1 ServoPneumatic axis Festo CPX-CMAX-C1-1 2019-02a English... - Page 8 10 ms (for systems with the DGCI, a power dropout > 1 ms causes an error) Axis string Number of axis strings/Number of axes 1 / 1 Max. total length (all cables) 30 m Type of axis connection Socket M9, 5-pin Festo CPX-CMAX-C1-1 2019-02a English...
Need help?
Do you have a question about the CPX Series and is the answer not in the manual?
Questions and answers