Host Usb Port; Installation; Sge02 Expansion Module; Antenna Port - Smartgen HGM9420N User Manual

18 HOST USB PORT

HGM9420N_HGM9420LT controller supports to insert U flash of FAT32 format. By inserting U flash, it
can realize:
 Lead-in and lead-out function of configured parameters
1. Check xxx.glm configuration files in the U flash;
2. Upload configuration files of HGM9400NXXXX.lgm format to controller;
3. Save controller configuration parameters to corresponding HGM9400NXXXX.lgm file;
4. Save new configuration file (HGM9400NXXXX.lgm).
 Historical data saving
Historical data saving files are named by year and month. For.dat files named by year-month-day,
genset saves data per minute at standby status, at other statuses data are saved per second. If the
memory room in the U flash is less than or equal to 200MB, then the earliest month memory files will be
deleted.
Historical data files are as below:
Historical data curves can be checked by the historical data analysis funtion of data iGMP6 software.

19 INSTALLATION

19.1 SGE02 EXPANSION MODULE

19.1.1 4G ANTENNA PORT
Connect 4G antenna with 4G port of SGE02.
Antenna port: 50Ω/SMA connector.

19.1.2 GPS ANTENNA PORT

By using GPS function, connect GPS antenna and GPS port of SGE02.
NOTE: GPS antenna needs to be put outdoor, otherwise location information is not correct or users cannot obtain location
information.
Antenna port: 50Ω/SMA receptacle, active antenna.
HGM9420N_HGM9420LT Genset Controller
HGM9420N_HGM9420LT GENSET CONTROLLER USER MANUAL
2019-12-10 Version 1.0 Page 99 of 112