Cycle Support; Programming Example For Turning Application - Siemens SINUMERIK User Manual

A.9.6

Cycle support

Functionality
The following technologies are provided with additional support in the form of pre-defined cycles, which then must be
parameterized.
● Drilling
● Turning
For more information, see Chapter "Cycles (Page 147)".
A.9.7

Programming example for turning application

Example 1
The following diagram shows a programming example for the "Free contour programming" function.
Operating sequence:
Programming and Operating Manual (Turning)
01/2017
1. Select the program management operating area.
2. Enter the system program directory.
3. Select a program with cursor keys and press this key to open the program in the program
editor.
4. Press this softkey to open the contour editor.
281