Calling A Standard Cycle With Auxiliary Functions - Siemens SINUMERIK 808D Function Manual

→
NOTICE
Poor performance of the system
Do not upload any manufacturer's file of a too large size; otherwise, the system performance will be reduced.
23.3

Calling a standard cycle with auxiliary functions

You can call user cycles with M codes or T codes. With this function, you can perform operations such as changing machine
tools.
Note
M codes or T codes for calling user cycles must not be in the same program segment.
Calling cycles with "M6"
Configure the parameters shown in the table below to activate an M code for calling a standard cycle:
No. Name
22550 TOOL_CHANGE_MODE
22560 TOOL_CHANGE_M_CODE
10715 M_NO_FCT_CYCLE[0]
10716 M_NO_FCT_CYCLE_NAME[0]
208
8. Press this hardkey to access the "OEM manual" folder, and then enter the "manual" folder,
that is, the above-mentioned third-level folder.
Paste the copied file(s) under this folder with the following:
→
9. Press these two keys in succession.
Then you can view your own machine manufacturer's manual.
10. Use this softkey to exit the machine manufacturer's manual.
Unit Value Description
- 1 Activating tool parameters with an M code
- 206 The M code for activating tool parameters
- 6 Calling the standard cycle with M06
- "TOOL" Name of the standard cycle
Function Manual
01/2017