Instructions For Installing New Software - Primus XCONTROL PLUS Original Programming Manual

ATTENTION!
!
MAKE SURE THAT THE SMALL HOSE OF THE LEVEL SENSOR IS CORRECTLY SECURED BY A
FLEXIBLE CLAMP.
IF THE HOSE IS NOT AIR TIGHT THEN THE LEVEL SENSOR WILL NOT MAKE A CORRECT MEASUREMENT.
MAKE SURE THAT YOU DON'T DAMAGE THE FLEX CABLE OF THE KEYPAD WHEN YOU PUT
THE WASH COMPUTER BACK INTO THE MACHINE.

9.5. INSTRUCTIONS FOR INSTALLING NEW SOFTWARE

 Switch the machine power supply off.
 Open the cover plate of the washing machine.
 Insert a flash drive containingn the software into the USB connector E (of the CPU board).
 Switch the machine power supply on.
 The display shows information that the software is being copied from the flash drive into the programmer board.
 When the copying is finished a prompt to remove the flash drive from the CPU is displayed.
 Switch the machine power supply off and remove the flash drive.
 Close the washing machine cover plate.
 Switch the machine power supply on.
 If the software is compatible with the previous software: the new software can be used without
re-initialization.
 You have to clear all the error messages in the Service-menu, if you want to make a correct
inspection of the functioning of the new installed software.
 If the software is not 100% compatible with the previous software version:
 The new software will generate a diagnostic message 35. When fault message 35 occurs you
have to reset the settings of the configuration and initialization menu.
 This can be easily done by Selecting Reset Factory Settings in the Configuration Menu.
 This is explained in Chapter 3 : Basic Description of Controls.
 Go through the Menu items of the Configuration and Initialization Menu one by one to ensure
that all the settings do correspond with the ones you prefer.
 All the Custom Settings will be lost.
540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMMING MANUAL
TROUBLESHOOTING
99