Cooldown Function; Spray Function; Unbalance; Pause - Primus XCONTROL PLUS Original Programming Manual

6.13. COOLDOWN FUNCTION

 AUTOMATIC COOLDOWN : this function avoids thermal shock in the washing machine.
 For Hot washes above 65°C, Cold water is added at the end of the step.
 PROGRAMMED COOLDOWN : this function is recommended to avoid the shrinking of the
garments.
 Water is drained and cold water is added bit by bit. The temperature of the water in the
tub will decrease slowly as a function of the programmed Cool-down Sequence
(temperature and time).

6.14. SPRAY FUNCTION

 The special product is injected while the drain valve is open and depending the
programmed speed, the drum will spin at distribution or low spin speed.

6.15. UNBALANCE

 When the machine is badly loaded during the spin sequence, then the tilt switch will get
activated.
 The spin sequence will be interrupted and the garments in the drum will be redistributed.
 The washing machine will try up to 5 times to redistribute the garments.

6.16. PAUSE

 When a signal has been programmed, at the end of a wash sequence, the machine will
stop the Program and the message „Pause, Press Start to Continue" will be displayed.
 The buzzer will give a warning for the operator.
 Now the operator can add Soap.
 By pressing the START button the PROGRAM will go on with the next Program step.

6.17. STOP

 By pressing the STOP button the program is interrupted.
 First the machine will go over to a safe state.
 Then the message CONTINUE ? is displayed.

STOP : the program is stopped. (A tumble sequence will be executed before the door can be
opened.)

START : the program restarts the last active step, and goes on with the rest of the program.

6.18. WAIT STATE

 It can occur that the normal machine operation has been interrupted and that you have to
wait until the Wash Computer allows you to go on.
 You can recognize the wait state by a display that shows WAIT and a decreasing counter.
 This will occur when the power has been switched off and on at a running wash cycle.
 As the software doesn't know how fast the motor was spinning, a delay time is respected
before the machine can be restarted.
54 PROGRAMOVACÍ MANUÁL 540876_A_PUB_DATE_1_FEB_2012.DOC