Primus XCONTROL PLUS Original Programming Manual page 84

FAILURE 8: DOOR LOCK CHECK AT START FAILURE
The washing machine will not start a new process when the door is not locked after pressing the START button.
Failure message 8 will be generated each time the door lock sequence could not be finished once started.
DIAGNOSE:
1. Check door handle for damage traces and
centering against door lock.
2. Check if the input connector DL (door lock)
is connected.
3. Check the well functioning of the door lock
switch.
4. Check the door lock coil.
5. Check the mechanical functionality of the
door lock.
6. Check the continuity of the wiring.
7. Check the output relay that powers the door
lock coil.
8. Check the good functioning of the door
lock switch at the inputs menu.
FAILURE 9: DOOR LOCK SWITCH FAILURE AT CYCLE END
At the end of the cycle the Door Lock coil is switched off and the door lock switch must open its contact.
If within 30 sec the „DOOR LOCK SOLENOID SWITCH" doesn't change state failure message 9 will be
displayed. As long the contact stay closed, failure message 9 stays on the display. If the contact should
change state, the error message will be removed from the display and machine will be ready for use again.
DIAGNOSE:
1. Check the functioning of the door lock
switch.
2. Check the door lock coil.
3. Check the mechanical functionality
of the door lock.
4. Check the continuity of the wiring.
5. Check the output relay that powers
the door lock coil.
84
If handle is damaged, replace hanle.
If not good centered, center door against door lock.
If the input connector DL (door lock) is not connected :
connect connector DL.
If the door lock switch is broken or doesn't function
correct: replace the door lock
If the door lock coil doesn't function: replace the door
lock coil.
If the door lock is not functioning mechanically and can
not be corrected: replace the door lock system.
If the wiring is not continuous : repair the wiring.
If the relay is broken, replace the wash computer.
If the input is not functional replace the wash
computer.
If the door switch is broken or doesn't function correct:
replace the door lock.
If the door lock coil doesn't function: replace the door lock.
If the door lock is not functioning mechanically and can not
be corrected: replace the door lock system.
If the wiring is not continuous: repair the wiring.
If the relay stays closed and the relay is broken, replace
the wash computer.
PROGRAMMING MANUAL 540876_A_PUB_DATE_1_FEB_2012.DOC