How To Get Into The Setup Mode - Primus XCONTROL PLUS Original Programming Manual

3.3. HOW TO GET INTO THE SETUP MODE

Press the SERVICE INFO button on the keypad.
Press the Arrow Down Button several times until you see the screen with the Menu Selection:
"To program mode press 0"
To pogram mode
Press 0 (the Zero button). You will see the Main Menu Screen.
If a Password was enabled first you have to Enter the right Password.
How to leave a setup mode
When the „Main Menu" screen is shown.
Press the SERVICE INFO button on the keypad. Then you will return to "Run Mode" and „SELECT
CYCLE" is shown.
10
SERVICE INFO
To Program Mode
Password
PROGRAMOVACÍ MANUÁL
Press 0
....
540876_A_PUB_DATE_1_FEB_2012.DOC