Primus XCONTROL PLUS Original Programming Manual page 21

Menu Item
Temperature Balance
Motor On Time
Motor Off Time
Smart Motion
Hot Water Heater Temp.
Temp. Overshoot Prot.
Max. Heating Time
540876_A_PUB_DATE_1_FEB_2012.DOC
Default Info
No
The right water temperature at the water fill process is
obtained by switching the cold and hot water inlet
valves. For high temperatures extra heating will be
required after the fill process. For some special
customer applications, it is allowed to switch off the
automatic Temperature Balance control.
12 Sec
At normal wash action, drum turns for 12 seconds.
Recommended 3 Sec for Gentle wash action.
(= suggested values for the program menu)
3 Sec
At normal wash action, drum is stopped for 3 seconds.
Recommended 12 Sec for Gentle wash action.
(= suggested values for the program menu)
Yes This option decreases the drum R.P.M. during water
filling therefore the laundry absorps water more quickly
and washing efficiency increases.
60 °C
The Hot Water Heater Temperature should correspond
with the hot water supply of the washing machine.
The value of the hot water supply temperature is
required to obtain a correct bath temperature at the
water fill process.
00 %
To avoid temperature overshoot at steam heating,
the % value is the reduced temperature at which the
heating is switching off before reaching the target
value. In the tub cold and hot water gets mixed and if
after 30 seconds the programmed target temperature
is not reached, the heating will be started again.
60 Min
A diagnostic message is generated by the wash
computer when the water hasn't reached the
programmed temperature in 60 Minutes. (Err 14)
Attention!
!
If 99 minutes has been selected, NO error message will be
generated at all, even if the heating time exceeds 99 minutes.
The machine will only stop heating when the programmed
temperature has been reached.
PROGRAMOVACÍ MANUÁL
SETUP
Limits
No / Yes
1 - 99 Sec
1 - 99 Sec
No / Yes
50 - 80 °C
0 - 30 %
10 - 90 Min
21