Primus XCONTROL PLUS Original Programming Manual page 28

Menu Item
Wet Cleaning
Erase All Wash Prog ?
Are You Sure ?
Load Standard Programs ?
Language
Load Program 1 - 20 ?
Load Program >20 ?
Communication Addr.
Exit
28
Default Info
No
Selection Wet Cleaning allows to program water
levels below the standard minimum programmable
levels. The heating will not be functional for a water
level below the standard minimum programmable
water level.
No
Allows erasing all the wash programs at once.
To be used only at the installation of a new wash
No
computer and if you want to ensure that no old
programs stay in the memory of the wash computer
anymore.
All the memory Blocks will be cleared one by one.
Attention!
!
Erase All Wash Programs must be executed for each new
installed wash Computer, to ensure correct EEPROM
memory configuration!
No
To use the 20 wash computer Standard Wash
programs, these standard programs must be loaded
into the Wash Program Memory of the wash computer.
English Choose the language of the Wash Program name.
The Wash Program name shows to the operator the
No
type of wash process.
A confirmation is asked to load Standard Programs.
No
Standard programs 1 - 20 see chapter 7.
It is also possible to load 37 dedicated programs.
Attention!
!
After selecting a different machine type, best is to load again
the Standard Programs in memory, this to avoid that the
washing machine runs with wrong water levels, drum speed.
255
Each washing machine in the serial RS485 washing
machine communication network must have a unique
Communication Address. (Master - Slave)
Attention!
!
If 2 or more machines have the same Communication
Address the communication network will not function
properly.
Return to Main Menu
PROGRAMOVACÍ MANUÁL
Limits
No / Yes
No / Yes
No / Yes
List
No / Yes
No / Yes
1 - 255
540876_A_PUB_DATE_1_FEB_2012.DOC