Primus XCONTROL PLUS Original Programming Manual page 26

Menu Item
Brightness Display
Inverter Menu...
Supply Voltage XXXXXXX
(Inverter Type)
Load Param...
Are You Sure ?
26
Default Info
12
The brightness of the display is changed by adjusting
the contrast of the optimal viewing angle.
Attention!
!
The washing machine can only operate correctly if the
right inverter (same as washing machine) has been
set in the Configuration menu.
Select the right inverter.

Look at Machine Name Plate on the rear of the
washing machine.

Select the Supply Voltage as shown on the
Machine Name Plate.
The frequency inverter will be selected by default.

Check Inverter Type
Attention!
!
The washing machine can only perform properly if the
inverter contains the right list of inverter parameters. By the
wash computer it is possible to load the list of parameters in
the inverter. Make sure that the correct Supply Voltage has
been selected first.
Attention!
!
Loading parameters is only required after installing a new
inverter.
Load the inverter Parameters.

Door must be closed.
No

Check if the SETUP is correct.
- Parameter List Version
- machine type, inverter type, softw version

Confirm that you want to load the inverter
Parameters.

Check status screen while parameters are loaded.
- Sending Param.: 0 - 100 %
- Verify Param: 0 - 100 %
PROGRAMOVACÍ MANUÁL
Limits
1 - 20
List
No / Yes
540876_A_PUB_DATE_1_FEB_2012.DOC