Primus XCONTROL PLUS Original Programming Manual page 45

 THE SOAK SEQUENCE
Prewash | Wash | Cooldown | Rinse | Final
Menu Item
Temperature
Inlet
Level
RPM
Detergents Menu...
Supply 1, ..., 8
On Time
Off Time
Time
Signal
540876_A_PUB_DATE_1_FEB_2012.DOC
Soak
Rinse | |
Default Info
40 °C
The water temperature.
I1 - I7
The suggested inlet valves are related to the
temperature and the soap box to be used.
Attention!
!
If you insert other inlet valves than the suggested ones,
problems can occur at the water fill process.
Normal
The suggested water level depends on the machine
Type.
Low
-
The suggested RPM depends on the machine Type.
Time selection for Soap Boxes (hopper) and external
liquid soap supplies.
0 sec
You can program up to 4 supplies at the same time.
If you have programmed more then 4 supplies an error
message will be generated. Put the time of the
supplies back to zero until not more than 4 non-zero
time values are remaining.
(Liquid soap supplies must be switched on at the configuration menu)
12 sec
The wash action, motor On Time.
(The suggested default values can be adjusted at the Initialization menu)
10 Min
The wash action, motor Off Time.
(The suggested default values can be adjusted at the Initialization menu)
1.0 Hour
The Soak Sequence Time.
(for 0 Hour the Soak sequence will be skipped)
(programmable in steps of 0,1 Hour)
No
When a signal is programmed, a pause will be
introduced at the end of the Wash Step. This allows
the operator to add soap for the next step. A buzzer
signal warns the operator that the cycle has been
interrupted.
PROGRAMOVACÍ MANUÁL
PROGRAMMING
Flush | Spray | No wash
Limits
1 - 45 °C
I1...I8
See table 3.5.A
See table 3.5.B
0 - 99 sec
1 - 99 sec
1 - 99 minutes
0 - 25.5 Hour
No / Yes
45