Primus XCONTROL PLUS Original Programming Manual page 17

 Programming the Wash Speed
 Standard reversing wash speed is between  40 and 50 RPM. ( Verify exact value at table 3.5.B.)
 For some special applications the drum should only turn very slowly.
- Speed Limits
 The minimum programmable wash speed is 10 RPM.
 The maximum programmable wash speed is 40 - 60 RPM, depending on machine size.
 Programming Extraction speed
Extraction  [150 - 1165] RPM
 An Intermediate spin between two sequences should be about ½ of the max spin.
 Between 90 and 150 RPM ( Verify exact value at table 3.5.B.) it's not allowed to program a steady
speed, as the machine could VIBRATE TOO MUCH.
- Speed Limits
 Check table 3.5.B with the minimum and maximum speed limits. The limits differ depending on the
maximum allowed g-force at high spin for each washing machine type.
 Programming Supplies
 Up to 4 Supplies can be programmed at the same time in a sequence.
 If Liquid soap pumps have been installed on the washing machine, then these pumps will be activated
by programming a time value for the corresponding supply signal 1, 2, 3, 4, 5, 6, 7, 8.
- Time Limits
 The maximum programmable time is 99 Seconds
 If the time is 0 Seconds then the supply will NOT be activated at the wash process.
ATTENTION!
!
IF FOR SOME SPECIAL APPLICATION MORE THAN 4 SUPPLIES MUST BE PROGRAMMED IN THE
SAME SEQUENCE, THIS CAN BE SOLVED BY PROGRAMMING THE SAME SEQUENCE TWICE; ONE
AFTER THE OTHER. SPLIT THE WATER LEVEL ( SO IT WILL TAKE WATER FOR THE SECOND FILL,
say 60%, 100%), STEP TIME, AND THE NUMBER OF SUPPLIES, OVER THE TWO SUBSEQUENT
SEQUENCES. PROGRAM A „NO DRAIN" BETWEEN THE TWO SEQUENCES TO AVOID DRAINING
THE WATER. SET TEMPERATURE THE SAME FOR BOTH PARTS.
540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL
INTRODUCTION
17