Primus XCONTROL PLUS Original Programming Manual page 41

 THE WASH SEQUENCE
Wash
Prewash |
Menu Item
Temperature
Inlet
Level
RPM
Detergents Menu...
Supply 1, ..., 8
On Time
Off Time
Time
Signal
540876_A_PUB_DATE_1_FEB_2012.DOC
| Cooldown | Rinse | Last Rinse
Default Info
60 °C
The water temperature.
I2-I3-I6-I8
The suggested inlet valves are related to the
temperature and the soap box to be used.
!
If you insert other inlet valves than the suggested ones,
problems can occur at the water fill process.
Normal
The suggested water level depends on the machine
Type.
Low
-
The suggested RPM depends on the machine Type.
Time selection for Soap Boxes (hopper) and external
liquid soap supplies.
0 sec
You can program up to 4 supplies at the same time.
If you have programmed more then 4 supplies an error
message will be generated. Put the time of the
supplies back to zero until not more than 4 non-zero
time values are remaining.
(Liquid soap supplies must be switched on at the configuration
Menu)
12 sec
The wash action, motor On Time.
Gentle wash action : 3 sec.
(The suggested default values can be adjusted at the Initialization
menu)
3 sec
The wash action, motor Off Time.
Gentle wash action : 12 sec.
(The suggested default values can be adjusted at the Initialization
menu)
7.0 Min
The Wash Sequence Time.
(for 0 Minutes the Wash sequence will be skipped)
(programmable in steps of 0,5 Minutes)
No
When a signal is programmed, a pause will be
introduced at the end of the Wash Step. This allows
the operator to add soap for the next step. A buzzer
signal warns the operator that the cycle has been
interrupted.
PROGRAMOVACÍ MANUÁL
| Soak | Spray | No wash
Attention!
PROGRAMMING
Limits
1 - 92 °C
I1...I8
See table 3.5.A
See table 3.5.B
0 - 99 sec
1 - 99 sec
1 - 99 sec
0 - 99.5 Min
No / Yes
41