Specific - Primus XCONTROL PLUS Original Programming Manual

3.2. SPECIFIC

 The PROGRAM Menu is designated for:
 the creation of a specific name for a wash program.
 the creation and implementation of a new wash program step by step.
 editing a wash program step by step.
 inserting and deleting steps in the wash program.
 copying a wash program.
 deleting a wash program.
 inspecting the wash program by the view function.
 The CONFIGURATION Menu is designated for :
 the selection of the machine type.
 loading the default factory settings for the CONFIGURATION and INITIALIZATION menu.
 the selection of the Brightness of the display.
 the selection of the power supply voltage of the washing machine.
 loading the frequency inverter parameters.
 erasing all the programmed wash programs (reset Wash program EEPROM memory).
 loading the standard wash programs.
 the selection of the number of wash machine water supply inlets.
 the selection of a second drain valve. (water recycling system)
 the selection if external liquid pumps have been connected to the washing machine.
 the selection if the temperature must be displayed in degrees Celsius or degrees Fahrenheit.
 the selection Full Heating.
 the selection of Wet Cleaning (very low programmable water levels).
 the selection of the minimum level start supplies.
 The INITIALIZATION Menu is designated for :
 the selection of the displayed Language.
 programming the Service due value.
 the selection of the Buzzer time interval.
 the selection of the Advance function.
 the selection of the Wait for temperature function.
 the selection of the Manual override function.
 the selection of the Temperature balance function.
 programming the Default Motor On and Off times for reversing wash action.
 the selection of the Automatic Cool-down function.
 programming the Boiler temperature (hot water supply).
 programming the Temperature Overshoot Protection value.
 programming the Maximum Heating time value.
 programming the Maximum Fill time value.
 programming the Maximum Level overfill value.
 The SERVICE Menu is designated for :
 the inspection of the error messages log register and the list with statistics.
 activating the power of the frequency inverter.
 the inspection of the functionality of the electric input signals.
 resetting the Cycle counter.
 The DIAGNOSTIC Menu is designated for :
 running a Diagnostic Program.
 The ADVANCED Menu is designated for :
 special optional applications
540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL
INTRODUCTION
9