Initializing The Machine; Initialization Menu - Primus XCONTROL PLUS Original Programming Manual

4. INITIALIZING THE MACHINE

Initializing the machine goes in four steps:
1. Install the machine mechanically. (See Installation Manual)
2. Select the machine specific settings in the Configuration Menu.
3. Select the operator specific settings in the Initialization Menu.
4. Adjust standard Programs or create new Programs at the Program Menu.
ATTENTION!
!
THE INITIALIZATION SHOULD BE PERFORMED BY QUALIFIED PERSONNEL ONLY. AN INCORRECT
INITIALIZATION MAY CAUSE SERIOUS INJURIES AND SERIOUS DAMAGE TO THE MACHINE!
ATTENTION!
!
BEFORE MAKING CHANGES IN THE CONFIGURATION AND INITIALIZATION MENU READ THIS MANUAL
CAREFULLY.
CHANGES YOU HAVE MADE WILL INFLUENCE THE WASH PROGRAM PROCESSES.
WE RECOMMEND BEFORE MAKING CHANGES TO CAREFULLY WRITE DOWN WHAT THE PREVIOUS
SETTINGS WERE.
AS THE WASH COMPUTER IS USED FOR A WHOLE RANGE OF WASHING MACHINES, AFTER THE
INSTALLATION OF A NEW WASH COMPUTER, YOU NEED TO PROGRAM MACHINE SPECIFIC
SETTINGS INTO THE CONFIGURATION MENU. SEE PARAGRAPH 4.2.
AT THE INSTALLATION OF NEW SOFTWARE, AFTER LOADING THE FACTORY SETTINGS (SEE
PARAGRAPH 4.2) YOU NEED TO CHECK THE DEFAULT SETTINGS ONE BY ONE TO FIND OUT IF
THEY CORRESPOND WITH THE SETUP AS YOU PREFER.
THE CONFIGURATION AND INITIALIZATION OF THE WASHING MACHINE HAS BEEN DONE
AT THE FACTORY. FOR THE CREATION OF NEW PROGRAMS, NO CHANGES HAVE TO BE MADE
IN THE INITIALIZATION OR CONFIGURATION MENUS.

4.1 INITIALIZATION MENU

 HOW TO GET INTO THE INITIALIZATION MENU
The initialization menu can only be accessed when the machine is in standby (the power is switched on, but
no program is started).
 Select Cycle is displayed.
 Switch the machine to the setup mode (see chapter 3.3).
 The Main menu is now available.
 The Initialization Menu is the first Menu.
540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL
SETUP
19