Warnings - Primus XCONTROL PLUS Original Programming Manual

2. WARNINGS AND SYMBOLS

2.1. WARNINGS

BEFORE OPERATING A MACHINE CONTROLLED BY AN ELECTRONIC PROGRAMMER, READ THIS
MANUAL. INCORRECT USE CAN RESULT IN SERIOUS INJURIES OR DAMAGE TO THE MACHINE
CONTROLS. IGNORING INSTRUCTIONS CAN CAUSE AN INCORRECT MACHINE FUNCTION, WHICH
MAY RESULT IN INJURIES OR MACHINE AND/OR LINEN DAMAGES.
– This English version is the original version of this manual. Without this version, the instructions are incomplete.
Before installation, operating and maintenance of the machine, read complete instructions thoroughly
which means the following manuals: „Original Programming Manual" and „Original Installation, maintenance
and user's manual". Follow these instructions and keep them handy for later use.
– A machine must be installed by following the „Original Installation, maintenance and user's manual". Before
the first machine start, it must be initialized and tested by a qualified worker.
– The electric service line must not be affected by other electrical loading. A nominal voltage, if loaded or not
must work in the range ±10% with a maximum permanent frequency deviation of 1% or a short-time one at
2% of a given frequency. Connecting or starting the machine at an incorrect voltage can damage the
programmer.
– The machine must not be exposed to high humidity or extreme high and low temperatures.
– Do not tamper with the controls.
INSTRUCTIONS IN THIS MANUAL DO NOT COVER ALL DANGEROUS SITUATIONS.
IT IS UP TO THE USER TO HANDLE THE MACHINE CAREFULLY.
The manufacturer has the right to change specifications in this manual without prior notice. All the stated
information is only for informative purpose and must be considered as general. It is not possible to present all
the specific data of the device.
NOTE!
EVERY CIRCUIT BOARD HAS A SERIAL NUMBER AND THE CODE OF THE BOARD (Picture 9.3).
THE MODEL AND SERIAL NUMBER OF THE MACHINE, MUST BE MENTIONED IN ALL CORRESPONDENCE
OR INQUIRIES ADDRESSED TO THE DISTRIBUTOR OR MANUFACTURER.
NOTE!
THE PROGRAMMER USES „MACHINE TYPE" CODES TO SELECT THE DIFFERENT PROGRAMMABLE
MACHINES EXECUTIONS.
The model number on the machine doesn't indicate the „machine type" but must be linked with the
description of the „machine type" letters.
540876_A_PUB_DATE_1_FEB_2012.DOC PROGRAMOVACÍ MANUÁL
INTRODUCTION
5