Calibrating The Standard Signal - ProMinent DULCOMETER D1Cb Series Instructions For Assembly And Use

Measured Variables and Operating Menus for the Standard Signal General

8.8 Calibrating the Standard Signal

In the reduced operating menu the DULCOMETER
In the complete operating menu the DULCOMETER
WARNING!
Incorrect metering due to incorrect metering range
Possible consequence: Fatal or serious injuries
–
The measuring range of the sensor or the measuring device is essential for the measuring
range!
–
If the assignment of the measuring range is modified, the settings must be checked in all
menus
–
If the assignment of the measuring range is changed, the sensor or the measuring device
must be recalibrated
CAUTION!
Correct sensor operation / Run-in time
Damage to the product or its surroundings
–
Correct measuring and metering is only possible if the sensor is working perfectly
–
Please read the operating manual for the sensor or the measuring device
–
It is imperative that the run-in times of the sensors or the measuring device are adhered to
–
The run-in times should be allowed for when planning initial operation
–
It may take a whole working day to run-in the sensor or the measuring device
90
® D1Cb calibrates the zero point.
D1Cb performs a two-point calibration.
®