Wall Mounted/Control Panel Mounted - ProMinent DULCOMETER D1Cb Series Instructions For Assembly And Use

Character Measured variable
H H O (Hydrogen peroxide)
2 2
I Chlorite
P pH
R Redox
S 0/4...20 mA standard signal general
X O
2
Z O
3
L Conductivity
*with reading transducer
Description of the terminal connections for mA and mV: refer to Fig. 11 and Fig. 12
Description of the operating menu of the measured variables via mV connection: refer to
7 "Measured Variables and Operating Menus for Potentiometric Sensors " on page 62
Description of the operating menu of the measured variables via mA connection: refer to
6 "Measured Variables and Operating Menus for Amperometric Sensors " on page 51
Description of the operating menu of the measured variables via mA standard signal: refer to
Ä Chapter 8 "Measured Variables and Operating Menus for the Standard Signal General "
on page 81
2.1 Wall Mounted/Control Panel
Mounted
The DULCOMETER ®
for wall-mounting, as well as for mounting on a
control panel (with additional control panel fixing
set).
The plastic housing comprises a housing upper
section and lower section. The LCD display and
membrane keypad are accommodated in the
upper section of the housing.
D1Cb W is suitable both
Functional Description
Connection of the measured variable
mV input
X
X
The lower section of the housing accommodates
the processor and power units and any optional
assemblies. A ribbon cable connects to the LCD
display and the membrane keypad.
The electrical connection is made through origi‐
nally sealed, push-out cable cut-outs on the
underside of the lower section of the housing.
A wall bracket for wall mounting is located on the
rear of the lower section of the housing.
to:
mA input
X
X
X*
X*
X
X
X
X
Ä Chapter
Ä Chapter
15