Electrical Installation (Control Panel Mounted) - ProMinent DULCOMETER D1Cb Series Instructions For Assembly And Use

1. Fit lock nut M12x1.5 (6) on the inside
2. Fit screw connection M12x1.5 (5) from
the outside and tighten firmly
3.4.3 Electrical Installation (Control
Panel Mounted)
Proceed as described under "Electrical Installa‐
tion (Wall Mounted)". Refer to
" Electrical Installation (Wall Mounted) "
on page 25
Only the rear row of threaded holes (M20x1.5)
should be used when the device is mounted in a
control panel. The front row (M12x1.5) lies
outside of the control panel.
Connect up as per the electrical terminal wiring
Ä Chapter 3.4.7 "Terminal
diagram. Refer to
Wiring Diagram " on page 31
Ä Chapter 3.4.2
Assembly
27