Changing The Measured Variable; Reduced / Complete Operating Menu - ProMinent DULCOMETER D1Cb Series Instructions For Assembly And Use

Measured Variables and Operating Menus for the Standard Signal General

8.2 Changing the Measured Variable

WARNING!
Incorrect metering due to incorrect measured variable
Possible consequence: Fatal or serious injuries
–
The measured variable/measuring range of the sensor is essential for the measured vari‐
able/measuring range!
–
If the measured variable/measuring range is changed, the sensor must be recalibrated
–
If the measured variable/measuring range is changed, the set points and limit values will be
changed to the associated starting values!
–
If the measured variable/measuring range is changed, the settings in all of the menus must
be checked
general setting
informationen
Fig. 39: Changing "Standard signal general" measured variable
For possible measured variables see

8.3 Reduced / Complete Operating Menu

The DULCOMETER
®
(reduced / complete). All of the parameters of the control unit are preset and can be changed in the
complete operating menu.
The controller is delivered with a reduced operating menu. If adjustments are necessary, the param‐
eters can be changed by switching to the complete operating menu.
Identcode:
D1CBxxxxxxx
Vxxxxxxxxxx
Srnr: xxxxxxxxxx
Ä Table on page 85 .
D1Cb allows settings to be made in two different comprehensive menus
Calib. timer
wash timer
measure change
add. functions
PAA
H2O2 (PER)
mA general
pH over mA
effective range
0...105 %
A0232_GB
83