Temperature Correction Value For Ph And Fluoride Sensors - ProMinent DULCOMETER D1Cb Series Instructions For Assembly And Use

Measured Variables and Operating Menus for Potentiometric Sensors

7.6 Temperature Correction Value for pH and Fluoride Sensors

CAUTION!
Influence of temperature on the pH or fluoride measurement
Possible consequence: Slight or minor injuries, material damage
Temperature changes in the sample water lead to a change in the gradient of the calibration lines
(pH, fluoride) and to a displacement of the zero point with pH sensors or the standard potential E
with fluoride sensors.
S
Measure to be taken to avoid this danger:
–
The pH or fluoride measurement should only be carried out in the
[Temperature Correction Value automatic] setting
–
The DULCOMETER
temperature sensor (Pt 100/Pt 1000) is connected
Fig. 38: Temperature Correction Value for pH and Fluoride Sensors
Temperature correction value for pH and fluoride sensors in line with the identcode:
As per identcode
0
2
4
® D1Cb then automatically compensates for both effects when a
only with correction value
correction value correcting value
temperature
setting ?
automatic
Possible values
Increment
Off
Off
Manual
Automatic
Off
Manual
A0020_GB
Lower value Upper value
79