Setting The Standard Signal Output - ProMinent DULCOMETER D1Cb Series Instructions For Assembly And Use

Factory setting Increment
Interference additive
variable:
interference
effect
Max. addi‐ 100 %
tive
actuating
variable
* Values below 1 Hz are treated as "Pause". To remove the Pause status, the frequency has to
exceed 2 Hz (hysteresis function)

9.6 Setting the Standard Signal Output

Only with standard signal output
mA output
setting ?
Fig. 60: Standard signal output
Operating Menus Independent of Measured Variables
Possible values
Lower value
multiplica‐
tive / additive
1 % -100 %
mA -output
measured value
0...20 mA
Upper value
+100 %
Control with standard signal
control
control value:
positive
negative
mA-output
measured value
0 mA = 0.00 ppm
20 mA = 1.00 ppm
mA-output
correcting value
0 mA = 0.0 °C
20 mA = 100.0 °C
Remarks
Maximum limit of
range used
Only with additive
actuating variable
mA-output
control value
- 100 %
0 mA =
20 mA =
0 %
A0031_GB
107