Measured Variables And Operating Menus For The Standard Signal General; Explanation Of The Standard Signal General - ProMinent DULCOMETER D1Cb Series Instructions For Assembly And Use

Measured Variables and Operating Menus for the Standard Signal General

8 Measured Variables and Operating Menus for the Standard
Signal General
8.1 Explanation of the Standard
Signal General
The "Standard Signal General" measured vari‐
able of the DULCOMETER
connect sensors from third party providers,
which emit a linear mA signal, to the
DULCOMETER D1Cb. The DULCOMETER
®
D1Cb is thus preconditioned with appropriate
sensors to measure and regulate a number of
physical measured variables, see
on page 85 .
D1Cb is used to
®
®
Ä Table
Adjusting the sensor output signal
The following steps must be taken in order to
adapt the DULCOMETER
signal from the sensor or measuring device:
NOTICE!
Linear characteristic line
As the DULCOMETER
process linear characteristic lines, only
sensors/measuring devices can be
connected, which emit a linear signal.
1.
Change the DULCOMETER
the complete operating menu
2. Set the required physical unit (measured
variable)
Display tolerances
With sensors or with output signals of meas‐
uring devices, which do not have to be cali‐
brated or with which calibration has to be
done in the sensor/measuring device, the
display tolerances must then be calibrated
between the sensor or measuring device
and the DULCOMETER
3. To do so, select the menu "Set
Reading", see
Reading " on page 84 .
4. The measuring range limit of 0/4 mA and
20 mA can be adjusted by raising and/or
lowering the readings
® D1Cb to the output
® D1Cb can only
® D1Cb to
D1Cb.
®
Ä Chapter 8.4 "Setting the
81