Table of Contents
Advertisement
Scope of Supply
6.1 Scope of supply
The following components are included as standard:
Description
Controller AGIb
Assembly material, complete
Operating Manuals on Flash Drive
General safety notes
6.2 Mechanical installation
6.2.1 Wall mounting
Mounting materials (contained in the scope of
supply)
1 x wall bracket
–
4 x PT screws 5 x 35 mm
–
4 x washers 5.3
–
4 x wall anchors Ø 8 mm, plastic
–
Wall mounting
1. Remove the wall bracket from the housing
2. Press the two snap hooks (1) outwards
The wall bracket snaps slightly downwards.
3. Push the wall bracket downwards (2) to clear the
housing and tilt it out (3)
sing and tilt it out (3)
4. Use the wall bracket as a drilling template to
the wall bracket as a drilling template to
mark the positions of 4 drill holes.
k the positions of 4 drill holes.
5. Drill the holes: Ø 8mm (5/16"), depth = 50mm
the holes: Ø 8mm (5/16"), depth = 50mm
(1.96")
6")
Quantity
y
y
y
1
2
1
1
Figure 5 Attaching the wall Bracket
1. Screw the wall bracket into position using the
washers provided. If needed, use the wall
anchors provided.
2. Hook the bottom of the housing (1) into the wall
bracket
3. Lightly press the housing at the top (2) against
the wall bracket
4. Then check that the housing is hooked in at the
top and press down (3) until it clicks into place.
Figure 7 Mounting the Wall Bracket
Figure 6 Removing the wall Bracket
Page 20 of 102
Advertisement
Table of Contents
