Checking The Odometer And Trip Meter; Displaying The Odometer, Trip Meter, And Oil Change Intervals - Denso VS-G Series Installation & Maintenance Manual

3.7

Checking the Odometer and Trip Meter

You may check the odometer and trip meter which count traversed distance of each
axis in the Odometer window of the teach pendant.
The access to the Odometer window is [F6 Set]—[F6 Maint.]—[F5 Odometer].
The Odometer window shows the following items:
[Odometer] Shows the total distance of each axis traversed after the robot leaves the
[Trip meter] Shows the distance of each axis traversed after you reset the trip meter
3.7.1

Displaying the Odometer, Trip Meter, and Oil Change Intervals

STEP 1
STEP 2
STEP 3
factory. You cannot reset the odometer.
to zero. You can reset the trip meter by pressing [F6 Reset] in the
Odometer window and following the guidance shown on the screen.
Turn the controller power ON.
On the teach pendant, set the mode switch to the MANUAL position.
On the top screen, press [F6 Set].
The Settings (Main) window appears as shown below.
Press [F6 Maint.].
88
F6