Siemens SINUMERIK Series Function Manual page 114

3 Setting up functions
3.4 Fault services
Function
Control
monitors
Initial setting
Status
Common start
date
New triggers
participation
Remaining memory and PLC performance index
Exchanging
addresses in
notifications
Next
synchronization
in
3-114
Description
Tree for selecting the control monitor to be
processed. It can be expanded to show the
triggers defined in it, which can be jumped to
directly.
Switches the currently active control monitors
on or off on the next synchronization.
Note:
Does not change the activation state of each
monitor.
The common start date defines the point at
which the trigger will begin to execute the
control monitor. Each time-based trigger can
be set so that it responds to the start date. If a
start date has not been specified, all of the
triggers react to the common start date with
the reaction identification.
Specifying dates in the past is not permitted.
Dates that are no more than 2 years in the
future can be specified.
Default setting for the function setting for trig-
gers: If an individual trigger setting has not
been made for participation at the start date,
the triggers will respond at the start date.
Overview of the remaining memory of the indi-
vidual PLC blocks and overview of the PLC
performance index currently in use and maxi-
mum PLC performance index:
 PLC trigger configurations
 PLC trace configurations
 PLC trace data
Remaining performance
An address that is configured in one or more
notifications of a control monitor can be re-
placed by another address from the organiza-
tion's address book.
Shows the time remaining until the next syn-
chronization: If the synchronization is overdue,
"Synchronization overdue since..." is dis-
played.
ePS Network Services, Function Manual (FH) - 03/2012
Type
TREE
DISPLAY
SELECTION
DISPLAY
SELECTION
DISPLAY
SELECTION
DISPLAY
ACTION
DISPLAY
© Siemens AG 2012 All Rights Reserved
03/2012