Siemens SINUMERIK Series Function Manual page 152

3 Setting up functions
3.4 Fault services
Function
[ ]
Delete
Add
Dependent
on start date
Each trigger can be assigned a label, which determines its behavior at the central
start date for maintenance.
See also Section: Editing the master data of a machine and the general description
of the trigger in Section: Setting up functions.
Options:

If a label has been set and a start date, which has not yet been reached, has
been configured in the master data, the trigger will not be initiated.

If the date has been reached or is in the past, the trigger will be initiated
according to the conditions set for it.

If a start date has not been configured, or the label has not been set, the
trigger will be initiated according to the conditions set for it.
Cyclic trigger on variable monitor
ePS Network Services restrict the use of variables for this
cyclic server trigger to an "endless counter" defined in the ePS Network Services.
The values read in a different control monitor action (execute variable monitor) can
be prompted in such a way that the trigger is initiated when a configured interval
value is reached or exceeded. The interval is then automatically projected onto the
interval grid for the next prompt.
Notice
PLC counters cannot be used as ePS Network Services counters! It is not possi-
ble to correct this configuration (counters). This configuration must be completely
deleted and re-entered.
Since it is not possible to use the endless counter function of the PLC, when a
smaller new value is read, ePS Network Services calculates this as an offset to
the old value.
3-152
Description
Unit of the counter.
Deletes the counter from the server trigger.
Adds another NC variable counter to the server
trigger.
This label specifies the dependency of the start
date for maintenance.
© Siemens AG 2012 All Rights Reserved
ePS Network Services, Function Manual (FH) - 03/2012
03/2012
Type
DISPLAY
ACTION
ACTION
DISPLAY
SELECTION
(Toggle)