Avaya J100 Series Installing And Administering page 254

Customizable parameters
Parameter name
ENHDIALSTAT
ENTRYNAME
EVENT_NOTIFY_AVAYA_MAX_USERS
July 2019 Installing and Administering Avaya J100 Series IP Phones
Comments on this document? infodev@avaya.com
Default Description
value
1 Specifies if the algorithm defined by
the parameter is used during
certain dialing behaviors.
Value operation:
• 0: Disables algorithm.
• 1: Enables algorithm, but not for
contacts.
• 2: Enables algorithm including
contacts.
Note:
The parameter is set to 0 for
IP Office environment.
0 Specifies if the calling party name,
or the VDN or the skill name must
be used in History entries.
Value operation:
• 0: Calling Party Name is used.
• 1: VDN or the skill name is used.
20 Specifies the maximum number of
users to be included in an event
notification message from CM/AST-
II or Avaya Aura
or later.
Valid values are 0 through 1000.
This parameter is used only for
development and debugging
purposes.
®
Conferencing 6.0
Table continues...
254