Table 110: L2 Protocol Tunnel Commands - Edge-Core ECS4620-28P Cli Reference Manual

Configuring L2PT Tunneling
l2protocol-tunnel
tunnel-dmac
Eth 1/ 3 Normal
. .
.
Console#show dot1q-tunnel interface ethernet 1/5
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID
-------- ----------- -----
Eth 1/ 5 1
Console#show dot1q-tunnel service 100
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID
-------- ----------- -----
Eth 1/ 5 1
Eth 1/ 6 1
Console#
Related Commands
switchport dot1q-tunnel mode
This section describes the commands used to configure Layer 2 Protocol Tunneling
(L2PT).

Table 110: L2 Protocol Tunnel Commands

Command
l2protocol-tunnel tunnel-
dmac
switchport
l2protocol-tunnel
show l2protocol-tunnel
This command configures the destination address for Layer 2 Protocol Tunneling
(L2PT). Use the no form to restore the default setting.
Syntax
l2protocol-tunnel tunnel-dmac mac-address
mac-address – The switch rewrites the destination MAC address in all
upstream L2PT protocol packets (i.e, STP BPDUs) to this value, and forwards
them on to uplink ports. The MAC address must be specified in the format
xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
The tunnel address can be any multicast address, except for the following:
IPv4 multicast addresses (with prefix 01-00-5E)
■
8100
100
100
100
(604)
Function
Configures the destination address for Layer 2 Protocol
Tunneling
Enables Layer 2 Protocol Tunneling for the specified
protocol
Shows settings for Layer 2 Protocol Tunneling
– 609 –
Chapter 21
| VLAN Commands
Configuring L2PT Tunneling
Mode
GC
IC
PE