Edge-Core ECS4620-28P Cli Reference Manual page 656

Chapter 23
| Quality of Service Commands
police trtcm-color
This command defines an enforcer for classified traffic based on a two rate three
color meter (trTCM). Use the no form to remove a policer.
Syntax
[no] police {trtcm-color-blind | trtcm-color-aware}
committed-rate committed-burst peak-rate peak-burst
conform-action transmit
exceed-action {drop | new-dscp}
violate action {drop | new-dscp}
trtcm-color-blind - Two rate three color meter in color-blind mode.
trtcm-color-aware - Two rate three color meter in color-aware mode.
committed-rate - Committed information rate (CIR) in kilobits per second.
(Range: 0-10000000 kbps at a granularity of 64 kbps or maximum port
speed, whichever is lower)
committed-burst - Committed burst size (BC) in bytes.
(Range: 64-16000000 at a granularity of 4k bytes)
peak-rate - Peak information rate (PIR) in kilobits per second.
(Range: 0-10000000 kbps at a granularity of 64 kbps or maximum port
speed, whichever is lower)
peak-burst - Peak burst size (BP) in bytes.
(Range: 64-16000000 at a granularity of 4k bytes)
conform-action - Action to take when rate is within the CIR and BP. (Packet
size does not exceed BP and there are enough tokens in bucket BC to
service the packet, the packet is set green.)
exceed-action - Action to take when rate exceeds the CIR but is within the
PIR. (Packet size exceeds BC but there are enough tokens in bucket BP to
service the packet, the packet is set yellow.)
violate-action - Action to take when rate exceeds the PIR. (There are not
enough tokens in bucket BP to service the packet, the packet is set red.)
drop - Drops packet as required by exceed-action or violate-action.
transmit - Transmits without taking any action.
new-dscp - Differentiated Service Code Point (DSCP) value. (Range: 0-63)
Default Setting
None
Command Mode
Policy Map Class Configuration
Command Usage
◆
You can configure up to 16 policers (i.e., class maps) for ingress ports.
◆
The committed-rate and peak-rate cannot exceed the configured interface
speed, and the committed-burst and peak-burst cannot exceed 16 Mbytes.
– 656 –