Edge-Core ECS4620-28P Cli Reference Manual page 441

Transceiver Threshold Configuration
transceiver-monitor
transceiver-threshold-
auto
Table 75: show interfaces switchport - display description
Field Description
802.1Q-tunnel Shows if 802.1Q tunnel is enabled on this interface
Status
802.1Q-tunnel Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel Uplink
Mode (page 604).
802.1Q-tunnel TPID Shows the Tag Protocol Identifier used for learning and switching packets
(page 607).
Layer 2 Protocol Shows if L2 Protocol Tunnel is enabled for spanning tree protocol
Tunnel
This command sends a trap when any of the transceiver's operational values fall
outside of specified thresholds. Use the no form to disable trap messages.
Syntax
[no] transceiver-monitor
Default Setting
Disabled
Command Mode
Interface Configuration (SFP/SFP+ Ports)
Example
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-monitor
Console#
This command uses default threshold settings obtained from the transceiver to
determine when an alarm or warning message should be sent. Use the no form to
disable this feature.
Syntax
transceiver-threshold-auto
Default Setting
Enabled
Command Mode
Interface Configuration (SFP/SFP+ Ports)
– 441 –
Chapter 11
| Interface Commands
Transceiver Threshold Configuration
(Continued)
(page 603).
(page 612).