Edge-Core ECS4620-28P Cli Reference Manual page 928

Chapter 30
| IP Interface Commands
IPv6 Interface
ipv6 address link-local
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 3.
ND retransmit interval is 1000 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised router lifetime is 1800 seconds
Console#
Related Commands
show ipv6 interface (932)
This command configures an IPv6 link-local address for an interface and enables
IPv6 on the interface. Use the no form without any arguments to remove all
manually configured IPv6 addresses from the interface. Use the no form with a
specific address to remove it from the interface.
Syntax
ipv6 address ipv6-address link-local
no ipv6 address [ipv6-address link-local]
ipv6-address - The IPv6 address assigned to the interface.
Default Setting
No IPv6 addresses are defined
Command Mode
Interface Configuration (VLAN)
Command Usage
◆
The specified address must be formatted according to RFC 2373 "IPv6
Addressing Architecture, " using 8 colon-separated 16-bit hexadecimal values.
One double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. And the address prefix
must be in the range of FE80~FEBF.
◆
The address specified with this command replaces a link-local address that was
automatically generated for the interface.
◆
You can configure multiple IPv6 global unicast addresses per interface, but only
one link-local address per interface.
◆
If a duplicate address is detected, a warning message is sent to the console.
– 928 –