Edge-Core ECS4620-28P Cli Reference Manual page 517

mac-address-table
This command maps a static address to a destination port in a VLAN. Use the no
form to remove an address.
static
Syntax
Default Setting
No static addresses are defined. The default mode is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port within a
specific VLAN. Use this command to add static addresses to the MAC Address Table.
Static addresses have the following characteristics:
◆
◆
◆
Example
mac-address-table static mac-address interface interface vlan vlan-id [action]
no mac-address-table static mac-address vlan vlan-id
mac-address - MAC address.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
vlan-id - VLAN ID (Range: 1-4094)
action -
delete-on-reset - Assignment lasts until the switch is reset.
permanent - Assignment is permanent.
Static addresses will not be removed from the address table when a given
interface link is down.
Static addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be ignored
and will not be written to the address table.
A static address cannot be learned on another port until the address is removed
with the no form of this command.
Console(config)#mac-address-table static 00-e0-29-94-34-de interface ethernet
1/1 vlan 1 delete-on-reset
Console(config)#
– 517 –
Chapter 18
| Address Table Commands