Edge-Core ECS4620-28P Cli Reference Manual page 985

Table 4: Routing Information Protocol Commands
Command
version
ip rip authentication mode
ip rip authentication string
ip rip receive version
ip rip receive-packet
ip rip send version
ip rip send-packet
ip rip split-horizon
clear ip rip route
show ip protocols rip
show ip rip
router rip
This command enables Routing Information Protocol (RIP) routing for all IP
interfaces on the router. Use the no form to disable it.
Syntax
[no] router rip
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
◆
RIP is used to specify how routers exchange routing table information.
◆
This command is also used to enter router configuration mode.
Example
Console(config)#router rip
Console(config-router)#
Related Commands
network (989)
Function
Specifies the RIP version to use on all network interfaces (if
not already specified with a receive version or send version
command)
Specifies the type of authentication used for RIP2 packets
Enables authentication for RIP2 packets and specifies keys IC
Sets the RIP receive version to use on a network interface
Configures the interface to receive of RIP packets
Sets the RIP send version to use on a network interface
Configures the interface to send RIP packets
Enables split-horizon or poison-reverse loop prevention
Clears specified data from the RIP routing table
Displays RIP process parameters
Displays information about RIP routes and configuration
settings
– 985 –
Chapter 50
| IP Routing Commands
Routing Information Protocol (RIP)
(Continued)
Mode
RC
IC
IC
IC
IC
IC
IC
PE
PE
PE