Edge-Core ECS4620-28P Cli Reference Manual page 597

switchport
This command enables ingress filtering for an interface. Use the no form to restore
the default.
ingress-filtering
Syntax
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆
◆
◆
◆
Example
The following example shows how to set the interface to port 1 and then enable
ingress filtering:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport ingress-filtering
Console(config-if)#
[no] switchport ingress-filtering
Ingress filtering only affects tagged frames.
If ingress filtering is disabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be flooded to all other ports (except
for those VLANs explicitly forbidden on this port).
If ingress filtering is enabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be discarded.
Ingress filtering does not affect VLAN independent BPDU frames, such as GVRP
or STA. However, they do affect VLAN dependent BPDU frames, such as GMRP.
– 597 –
Chapter 21
| VLAN Commands
Configuring VLAN Interfaces