Edge-Core ECS4620-28P Cli Reference Manual page 753

mvr6
proxy-query-interval
mvr6 proxy-switching
Example
The following example maps a range of MVR6 group addresses to a profile:
Console(config)#mvr6 profile rd ff01:0:0:0:0:0:0:fe ff01:0:0:0:0:0:0:ff
Console(config)#
This command configures the interval at which the receiver port sends out general
queries. Use the no form to restore the default setting.
Syntax
mvr6 proxy-query-interval interval
no mvr6 proxy-query-interval
interval - The interval at which the receiver port sends out general queries.
(Range: 2-31744 seconds)
Default Setting
125 seconds
Command Mode
Global Configuration
Command Usage
This command sets the general query interval at which active receiver ports send
out general queries. This interval is only effective when proxy switching is enabled
with the mvr6 proxy-switching
Example
This example sets the proxy query interval for MVR6.
Console(config)#mvr6 proxy-query-interval 228
Console(config)#
This command enables MVR6 proxy switching, where the source port acts as a host,
and the receiver port acts as an MVR6 router with querier service enabled. Use the
no form to disable this function.
Syntax
[no] mvr6 proxy-switching
Default Setting
Enabled
Chapter 24
command.
– 753 –
| Multicast Filtering Commands
MVR for IPv6