Edge-Core ECS4620-28P Cli Reference Manual page 797

lldp refresh-interval
lldp reinit-delay
◆
Information about changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the time of a
notification are included in the transmission. An SNMP agent should therefore
periodically check the value of lldpStatsRemTableLastChangeTime to detect
any lldpRemTablesChange notification-events missed due to throttling or
transmission loss.
Example
Console(config)#lldp notification-interval 30
Console(config)#
This command configures the periodic transmit interval for LLDP advertisements.
Use the no form to restore the default setting.
Syntax
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP advertisements are
sent. (Range: 5 - 32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Example
Console(config)#lldp refresh-interval 60
Console(config)#
This command configures the delay before attempting to re-initialize after LLDP
ports are disabled or the link goes down. Use the no form to restore the default
setting.
Syntax
lldp reinit-delay seconds
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP.
(Range: 1 - 10 seconds)
Default Setting
2 seconds
– 797 –
Chapter 25
| LLDP Commands