Table 49: Management Ip Filter Commands - Edge-Core ECS4620-28P Cli Reference Manual

Chapter 8
| Authentication Commands
Management IP Filter
Management IP Filter
management
Reauth Count
Current Identifier
Backend State Machine
State
Request Count
Identifier(Server)
Reauthentication State Machine
State
Console#
This section describes commands used to configure IP management access to the
switch.

Table 49: Management IP Filter Commands

Command
management
show management
This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. A list of up to 15 IP addresses or IP
address groups can be specified. Use the no form to restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client | telnet-client} start-
address [end-address]
all-client - Adds IP address(es) to all groups.
http-client - Adds IP address(es) to the web group.
snmp-client - Adds IP address(es) to the SNMP group.
telnet-client - Adds IP address(es) to the Telnet group.
start-address - A single IP address, or the starting address of a range.
end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
: 0
: 3
: Idle
: 0
: 2
: Initialize
Function
Configures IP addresses that are allowed management
access
Displays the switch to be monitored or configured from a
browser
– 300 –
Mode
GC
PE